Skip to main content
tools

cMC Tools

Specifications
Complete cMC toolkit (115993)

Includes all the tools listed below unless noted

End block lifting tool (106638)

Hold the end block during installation

Laser alignment tool kit (includes target and laser tool) (101509)

Align the end block to the outboard assembly during installation; prevents premature part wea

T-handle torque wrench (108147)

Tighten the drive belt to the optimum amount to prevent slippage and premature wear

Magnet bar install and removal tool (114694)

Insert and remove the magnet bar during target changes

End shield and end cap bushing gauge (117342)

Check for excessive wear on the outboard assembly bushing and the target end cap bushing (go/no-go gauge); for use every vent

Magnet bar support bushing tool (101518)

Press the bushing into the target end cap

Target end shield bushing tool (101516)

Press the bushing in and out of the outboard assembly

Bearing installation tool (101998)

1) Press the vacuum seal assembly into the end block, and 2) press the bearings onto the drive shaft

Water seal cartridge tool (102007)

1) Pull the water seal cartridge out of the end block, and 2) press the water seal cartridge into the end block

Vacuum and water seal tool (102006)

Press the vacuum and water seals into the seal housings

Drive shaft tool (115138)

1) Push the drive shaft assembly out of the end block, and 2) pull the drive shaft into the end block

Target lifting tool (sold separately) (102049)

Install and remove the target with vertically-oriented cathodes