SM/SMS Tools

Includes all the tools listed below unless noted

Move the end block during installation and maintenance

Align the end block to the outboard assembly during installation; prevents premature part wear

Insert and remove the magnet bar during target changes

Align the magnet assembly slot to the key in the end block during target installation

Set the magnet bar sputter angle

Check for excessive wear on the outboard assembly bushing and the target end cap bushing (go/no-go gauge); for use every vent

Press the bushing into the target end cap

Press the bushing in and out of the outboard assembly

Remove and install the vacuum seal assembly

Press the water seals into the seal housing

1) Push the drive shaft assembly out of the end block, and 2) pull the drive shaft assembly into the end block

1) Remove the bearings from the drive shaft, 2) press the bearings onto the drive shaft, and 3) install the pulley onto the drive shaft

Tighten the drive belt to the optimum amount to prevent slippage and premature wear

Support and rotate the end block during maintenance

Move the end block in place during installation with vertically-oriented cathodes.